project F:Realisation-f
From student
(Difference between revisions)
(→Pressure sensors) |
(→Pressure sensors) |
||
Line 23: | Line 23: | ||
[http://www.kobakant.at/DIY/?p=1781 Stretch] | [http://www.kobakant.at/DIY/?p=1781 Stretch] | ||
+ | : conductive thread or wire | ||
[http://www.kobakant.at/DIY/?p=1836 Stretch (conductive paint)] | [http://www.kobakant.at/DIY/?p=1836 Stretch (conductive paint)] | ||
: [http://www.kobakant.at/DIY/?p=634 Conductive paints and inks] | : [http://www.kobakant.at/DIY/?p=634 Conductive paints and inks] | ||
+ | : based on resistance difference when the canvas is stretched |
Revision as of 13:54, 12 January 2012
Design Realisation Relationships
Design Execution Prototype Validation Arduino development 1:1 Prototype
Arduino development
Pseudocode for controlling the air valves
Light sensor is in the place of motion sensor. Green led is the air OUT valve, the red is air IN. Air pressure is not measured, but it is a variable, that is changed by "letting air in / out".
Yellow led in the middle represents the air pressure. Bright: high pressure (cushion filled with air). Dim: low pressure (minimum pressure in the cushion).
When there is movement (light on the sensor), more air is pumped in (red led on). Otherwise the other valve starts to let air out (green led on).
Pressure sensors
- conductive thread or wire
- Conductive paints and inks
- based on resistance difference when the canvas is stretched